3Com 3C16700A User Manual
Officeconnect, Ethernet hub 4, 4c, 8, 8c
Table of contents
Document Outline
- OfficeConnect® Ethernet Hub 4, 4C, 8, 8C
- 3Com Corporation n 5400 Bayfront Plaza n Santa Clara, California n 95052-8145
- What Else Do I Need?
- Stacking the Units Together
- The Rubber Feet
- The Stacking Clip
- 1 Place your unit on a flat surface.
- 2 Fit the clip across the top of the unit, as shown in Figure 3 (picture 1), ensuring that the lo...
- 3 Align the fastening pieces over the slots found on each side of the unit.
- 4 Push the clip down gently to secure it, ensuring the fastening pieces snap into the slots on th...
- 1 Rest the second unit on top of the clip and align it with the front of the unit below.
- 2 Press down gently on the unit to secure it onto the clip, ensuring the fastening pieces fit int...
- Figure 3 Stacking Your Units Together
- Positioning Your Hub
- Securing Your Hub
- Using Your Hub
- Connecting Workstations and Other Equipment to Your Hub
- Connecting OfficeConnect Ethernet Hubs Together
- Spot Checks
- Connecting Workstations and Other Equipment to Your Hub
- Connecting OfficeConnect Ethernet Hubs Together
- Spot Checks
- Dimensions and Operating Conditions
- Standards
- Online Technical Services
- World Wide Web Site
- 3Com Knowledgebase Web Services
- Support from Your Network Supplier
- Support from 3Com
- Returning Products forRepair
- Hardware
- Software
- Year 2000 Warranty
- Obtaining Warranty Service
- Warranties Exclusive
- Limitation of Liability
- Disclaimer
- Governing Law
- FCC Statement
- CSA Statement
- VCCI Statement
- BCIQ Statement
- Information To The User