3Com XL PCI 10 - Manual (Page 28)

2-10 C HAPTER 2: I NSTALLING THE N ETWORK D RIVER
Novell NetWare Client Driver
This section describes how to install the Novell NetWare
client driver for a PC running DOS, Windows 3.x, or
Windows for Workgroups. You use 3Com AutoLink
software to install DOS client software and drivers for
Novell NetWare 3.1x or 4.x.
Do not use the AutoLink driver installation software if you
are running Windows 95 or Windows NT. See the previous
sections in this chapter for procedures to install network
drivers under these operating systems.
AutoLink software modifies the CONFIG.SYS and
AUTOEXEC.BAT files. It adds several lines to the
AUTOEXEC.BAT file and saves the old file as
AUTOEXEC.3CM. It also adds lines to the CONFIG.SYS
file and saves the old file as CONFIG.3CM.
AutoLink software logs on to the server and updates the
client software if your MIS department has already
configured a 3Install account on your server.
To use AutoLink software, your PC should have only one
3C900B NIC installed and at least 1 MB of available hard
disk space.
Running AutoLink Software
Follow these steps to run AutoLink software to install the
DOS client software and drivers for a NetWare network:
1 Install the NIC, connect to the network, and reboot
using a DOS diskette.
2 Insert EtherDisk diskette 1 in drive A.
3 Run the Install program. Enter:
a:install
The main menu is displayed.
4 Select Auto Install and Config for NetWare (AutoLink)
and press Enter.
5 Select DOS, Windows 3.1x, or Windows for
Workgroups 3.11, and follow the instructions.