3Com 3C389 - Manual (Page 57)

5-10 C HAPTER 5: T ROUBLESHOOTING
Diagnostics Error Codes and Suggested Actions
Initialization Error Codes
Failure during PC Card initialization usually indicates a
hardware error on the PC Card. Reboot your PC using the
diagnostic diskette (TokenDisk diskette #1 is a bootable
diskette), and run the diagnostic program again. If the
3C389 PC Card continues to fail, replace the card and
cable.
One of the following codes will be shown to indicate the
results of the initialization test. The error codes are
displayed in hexadecimal format and represent the
BRING_UP_CODE set by the 3C389 PC Card.
0000 Initialization success
0020 Diagnostics could not be executed
0022 ROM diagnostics failed
0024 Shared RAM diagnostics failed
0026 Processor instruction test failed
0028 Processor interrupt test failed
002A Shared RAM interface register diagnostics failed
002C Protocol-handler diagnostics failed
0040 PC Card’s programmable timer for the
computer failed (set by the microcode)
0042 Cannot write to shared RAM (set by microcode)
0044 Reading from shared RAM read-only area
caused an incorrect error indication (interrupt)
0046 Writing into shared RAM read-only area did not
cause an error indication (interrupt)
0048 Initialization timed out