3Com 3C389 - Manual (Page 53)

5-6 C HAPTER 5: T ROUBLESHOOTING
DXMCSMOD Error Codes
Table 5-2 DXMCSMOD Error Codes, Explanation, and Action
Error Code Explanation and Action
DXMCS 18I The 3C389 PC Card is ready to attach to the ring. It is
configured for the displayed ring speed in Mbps. Enter Y if
this is correct. If you would like to change the configured ring
speed, enter C to change.
The PC Card permits you to select the ring speed it will use.
You can respond to the question or prevent the question
from being asked by removing the PROMPT keyword in
LSP.INI.
DXMCS 19I Changing the ring speed configuration to xx Mbps.
This message is displayed in response to the user input from
message DXMCS 18I.
No action indicated.
DXMCS 20I Ring speed will REMAIN at xx Mbps.
This message is displayed in response to the user input from
message DXMCS 18I.
No action indicated.
DXMCS 21E An error occurred during configuration.
An error prevented DXMCSMOD from configuring the PC
Card using the parameters entered in LSP.INI.
Verify that the parameters entered in LSP.INI do not conflict
with other settings in the computer. The possible conflicts are
memory and interrupt settings.
DXMCS 22I No Card Services present.
DXMCSMOD cannot locate Card Services.
Ensure that the Card Services drivers have been loaded before
DXMCSMOD loads.
DXMCS 23I An error occurred when accessing the LSP.INI file.
The LSP.INI file could not be read. The file may either be
corrupted or not be present in the same directory as
DXMCSMOD.
Verify that theLSP.INI file exists. Reinstall DXMCSMOD
using the installation aid.
DXMCS 24E An error occurred when the program was accessing
PARSEINI.COM.
The PARSEINI.COM file could not be read. The file may
either be corrupted or not be present in the same directory
as DXMCSMOD.
Check that the PARSEINI.COM file exists in the same
directory as DXMCSMOD.