3Com 3C389 - Manual (Page 37)

OS/2 NDIS 2 Device Driver Using Multiprotocol Transport Service (MPTS) 3-13
■
From an OS/2 window, go into the IBMCOM
subdirectory and enter mpts at the OS/2 prompt.
2 Click OK on the MPTS logo panel.
3 Click Install.
You will be prompted for the source of the .NIF file.
4 Insert TokenDisk diskette #2 in the floppy drive.
5 Click OK when the Installation Complete message
appears.
You will return to the main menu.
6 Click Configure in the MPTS dialog box.
7 On the Configure panel, make sure that LAN
adapters and protocols is preselected and then click
Configure at the bottom of the panel.
8 In the Configuration panel, in the Network Adapters
group box, select 3Com TokenLink Velocity PC Card
and click ADD.
You can edit parameter settings for the 3C389 PC Card.
Highlight this NIC in the Current Configuration list box
and click Edit. When you have finished with the
parameter settings, click OK.
9 In the Protocols list box, select the protocols used by
your network application and click ADD.
If you are not sure which ones to use, select IBM
IEEE 802.2 and IBM OS/2 NetBIOS protocol drivers or ask
your network administrator.
The protocol drivers you have selected will appear under
the NIC driver name in the Current Configuration list box.
You can edit parameter settings for the protocols.
Highlight a protocol and select Edit.
10 Click OK when you have finished selecting and
editing protocols in the Configuration panel.
11 Click Close on the Configure panel.
12 Click Exit in the MPTS dialog box.
13 Click Exit on the Update CONFIG.SYS panel to
update the CONFIG.SYS file.