3Com 3C389 - Manual (Page 29)

Windows for Workgroups/NDIS 2 Installation 3-5
If you are running Windows for Workgroups Version 3.11,
perform the following procedure:
1 At the Network Setup window, select Networks,
then Install Microsoft Windows Network.
2 Change any other items for your environment, and
click OK and Continue.
3 When prompted to install a new PC Card, select
Unlisted or Updated Network Adapter.
4 When prompted to insert a diskette that contains
the network driver, insert TokenDisk diskette #2
and click OK.
5 Follow the instructions as they appear on the
window to install the device driver.
6 Accept the defaults for Interrupt, MMIO, and SRAM.
You will be given a chance to update these later, if
necessary.
7 Exit the Windows for Workgroups setup.
8 Exit to the DOS prompt. Do not reboot your PC at
this time.
9 Configure the 3C389 PC Card using LANAID.
See Chapter 5 for information on how to use LANAID.
10 If LANAID is not already installed, install it as
described in Chapter 4 in the section “Installing
LANAID.”
11 After LANAID is installed, continue with Chapter 4
“Using LANAID to Configure the 3C389 PC Card.”
When you get to the panel that asks for the existing
network operating system, select Microsoft windows for
workgroups.