Xerox 510DP (Operator Manual) - Manual (Page 30)

OFF-LINE SETUP MENU
20 XEROX WIDE FORMAT 510dp OPERATOR MANUAL
Printer Menu
The Printer Menu allows you to control the operation of the printer.
This menu contains six options. The table below describes the
Printer Menu options and their sub-options.
Table 1. Printer Menu options
Option Sub-option Function
KEYPRESS Enables or disables an audible beeper when a
control panel key is pressed.
Settings:
ON and OFF
Default: ON
AUDIBLE INDICATORS
ALARM Enables or disables an audible beeper when
the printer experiences a condition requiring
immediate attention.
Settings:
ON and OFF
Default: ON
READY TO POWER SAVER Controls the length of time the printer will
remain idle before entering power saver
mode.
Settings: 5 to 50 minutes in 5-minute intervals
Default: 50 minutes
NOTE: A value of 0 prevents the printer from
entering power saver mode. TIMERS
POWER SAVER TO REST Controls the length of time the printer will
remain idle in power saver mode before
entering rest mode.
Settings: 15 to 150 minutes in 15-minute
intervals
Default: 150 minutes
NOTE: A value of 0 prevents the printer from
entering rest mode.
PRINTER ADJUSTMENTS DENSITY Increases or decreases the print density.
Settings:
0 (lightest) to 10 (darkest)
Default: 5
FINISHER SETTINGS FINISHER CONFIG TYPE Specifies the folder configuration type.
Settings: NONE (no finisher) and 003
(Generic Finisher Interface)
Default: NONE