Appendix b, Serial data communications 69, Communication interfaces 69 – Zebra Technologies Zebra Z4000 User Manual
Page 78: Electrical noise 69, Chassis ground 69, Dsr (data set ready) 69, Dtr (data terminal ready) 69, Rts (request to send) 69, Rxd (receive data) 69, Signal ground 69
Exiting the Configuration mode
When you are finished changing or reviewing the necessary parame-
ters, press the START/SAVE key. Use the NEXT ITEM key to select
one of the “SAVE” choices shown below; then press the START/
SAVE key again to end the configuration process.
n
PERMANENT - new settings overwrite previous values in
configuration memory.
n
TEMPORARY - printer operates with new settings until power
is turned off; when power is turned back on, the printer
reverts back to the PERMANENT values.
n
CANCEL - printer makes no changes and returns to the current
settings.
n
LOAD DEFAULTS - all values return to the factory settings.
n
LOAD LAST SAVE - printer operates with last set of values
saved (either permanent or temporary).
70
Z Series™ User’s Guide
78
H:...uspiran2.vp
Thu Jun 18 16:03:37 1998
Color profile: Disabled
Composite Default screen