Zebra Technologies Zebra Z4000 - Manual (Page 72)

64 Z Series™ User’s Guide
COMMUNICATIONS
PARAMETER SELECTIONS
BAUD
(password
required)
Select the value that matches the one used by the
host.
Default: 9600
Choices: 600, 1200, 2400, 4800, 9600,
19200, 28800, or 38400
DATA BITS
(password
required)
Select the value that matches the one used by the
host. (Must be set to 8 data bits to use Code Page 850.)
Default: 8 bits/character
Choices: 7 bits/character or 8 bits/character
NOTE: The printer requires one (1) stop bit
minimum on received data and
automatically supplies two (2) stop bits
for transmitted data.
PARITY
(password
required)
Select the value that matches the one used by the
host.
Default: None Choices: Even, Odd, None
HOST HANDSHAKE
(password
required)
Select the value that matches the one used by the
host.
Default: XON/XOFF
Choices: XON/XOFF or DTR/DSR
PROTOCOL
(password
required)
Details on protocol can be found in the ZPL II
Programming Guide, available from Zebra
Technologies Corporation.
Default: None Choices: None, Ack-Nak, Zebra
NOTE: Zebra Protocol is the same as ACK/NAK
except that with Zebra the response
messages are sequenced. If Ack-Nak or
Zebra is selected, then “DTR/DSR” Host
Handshake must be selected.
SERIAL COMM
(password
required)
Select the choice that matches the one used by the
host.
Default: RS232 Choices: RS232, RS422/RS485,
or RS485 Multidrop
Continued on the following page.
72
H:...uspiran2.vp
Thu Jun 18 16:03:36 1998
Color profile: Disabled
Composite Default screen