Zebra Technologies Zebra Z4000 - Manual (Page 77)

Z Series™ User’s Guide 69
ADVANCED SETUP
PARAMETER SELECTIONS
BACKFEED
(password
required)
In the Cutter mode, this parameter establishes
when and how much label backfeed occurs after a
label is cut. It has no effect in the Tear-Off, Peel, or
Rewind modes. This parameter can be superseded
by the ~JS instruction when received as part of a
label format. (Refer to the ZPL Programming
Guide.)
Default: Default (default is defined as 90%)
Choices: Default, After, Off, Before, 10%, 20%,
30%, 40%, 50%, 60%, 70%, 80%
NOTE: The difference between the value entered and
100% establishes how much backfeed occurs
before the next label is printed. For example, a
value of 40 means that 40% of the backfeed
takes place after the label is cut. The remaining
60% takes place before the next label prints. A
value of “before” means that all backfeed will
take place before the next label is printed.
LEFT POSITION This parameter establishes how far from the left
edge of a label the format will begin to print by
adjusting the horizontal positioning on the label.
Positive numbers adjust the printing to the left by
the number of dots selected. Negative numbers
shift printing to the right.
Default: 000
Choices: -9999 to +9999
NOTE: For a negative value, enter the value before
entering the minus sign.
INITIALIZE CARD
(password
required)
This parameter allows you to initialize (erase) the
PCMCIA Card installed in the optional PCMCIA Port.
Press + to initialize. Then, if not sure, press - for
NO, or if you are sure, press + for YES.
INIT FLASH MEM
(password
required)
This parameter allows you to initialize (erase) the
optional non-volatile memory installed in the
printer.
Press + to initialize. Then, if not sure, press - for
NO, or if you are sure, press + for YES.
Continued on the following page.
77
H:...uspiran2.vp
Thu Jun 18 16:03:37 1998
Color profile: Disabled
Composite Default screen