Yamaha MCR-E810 - Manual (Page 42)

38
En
FM/AM Tuning
■ To switch the frequency step
(Asia and Taiwan models only)
Because the interstation frequency spacing differs in
different areas, you may need to switch the frequency step
mode.
1
While the receiver is in the standby mode,
hold down PRESET/BAND on the front panel,
and then press STANDBY/ON.
The receiver turns on.
2
Press PRESET/BAND repeatedly to select
“FM 50k/AM 9k” or “FM 100k/AM 10k”.
3
To confirm the setting, press STANDBY/ON.
Follow the procedure below to preset radio stations
automatically.
1
Rotate INPUT on the front panel of the receiver
to select “TUNER” as an input source.
2
Hold down MEMORY for more than two
seconds.
The AUTO and MEMORY indicator flash in the front
panel display.
• Auto Preset starts at the lowest frequency toward
the highest frequency.
• The receiver automatically applies a preset number
to each detected station.
• You can preset up to 40 of AM and FM stations by automatic
preset tuning.
• (U.K. and Europe models only)
Only Radio Data System broadcasting stations and AM stations
are stored automatically by automatic preset tuning.
MIN MAX
VOLUME
INPUT BALANCE
L R
TREBLE BASS
PHONES
STANDBY/ON
TIMER DISPLAY MEMORY
NATURAL SOUND STEREO RECEIVER RX-E810
PRESET/BAND PRESET/TUNING
PURE DIRECT
HOUR TIMER TIME ADJ MIN
AUTO/MAN'L
PRESET/BAND STANDBY/ON
Automatic preset tuning
Notes
MIN MAX
VOLUME
INPUT BALANCE
L R
TREBLE BASS
PHONES
STANDBY/ON
TIMER DISPLAY MEMORY
NATURAL SOUND STEREO RECEIVER RX-E810
PRESET/BAND PRESET/TUNING
PURE DIRECT
HOUR TIMER TIME ADJ MIN
AUTO/MAN'L
MEMORY INPUT