Xerox 150 - Manual (Page 84)

DocuMate 150 Scanner User’s Guide 79
Section 4: Electrical Information
Warning - Electrical Safety Information
1. The power receptacle for the machine must meet the requirements
stated on the data plate on the rear of the machine. If you are not sure
that your electrical supply meets the requirements, please consult
your local power company or an electrician for advice.
2. The socket outlet shall be installed near the equipment and shall be
easily accessible.
3. Use the power cable that is supplied with your machine. Do not use
an extension cord or remove or modify the power cord plug.
4. Plug the power cable directly into a correctly grounded electrical
outlet. If you are not sure whether or not an outlet is correctly
grounded, consult an electrician.
5. Do not use an adapter to connect any Xerox equipment to an
electrical outlet that lacks a ground connection terminal.
6. Do not place this equipment where people might step or trip on the
power cable.
7. Do not place objects on the power cable.
8. Do not override or disable electrical or mechanical interlock devices.
9. Do not push objects into slots or openings on the machine. Electrical
shock or fire may result.
Electrical Supply
1. This product shall be operated from the type of electrical supply
indicted on the product’s data plate label. If you are not sure that your
electrical supply meets the requirements, please consult your local
power company for advice.
2. WARNING: This equipment must be connected to a protective earth
circuit. This equipment is supplied with a plug that has a protective
earth pin. This plug will only fit into an earthed electrical outlet. This is
a safety feature. If you are unable to insert the plug into the outlet,
contact your electrician to replace the outlet.
3. Always connect equipment to a correctly grounded power outlet. If in
doubt, have the outlet checked by a qualified electrician.
Disconnect Device
The power cable is the disconnect device for this equipment. It is
attached to the back of the machine as a plug-in device. To remove all
electrical power from the equipment, disconnect the power cable from the
electrical outlet.