ZyXEL Communications G-302 - Manual (Page 35)

ZyXEL G-302 v3 User’s Guide
Chapter 3 ZyXEL Utility Configuration 35
3.2.2.1 WEP Encryption
Figure 15 Security Settings: WEP
The following table describes the labels in this screen.
Table 6 Security Settings: WEP
LABEL DESCRIPTION
WEP Select 64 Bits or 128 Bits to activate WEP encryption and then fill in the related
fields.
Authentication
Type
Select an authentication type. Choices are Open and Shared. Refer to Section 2.3
on page 29 for more information.
Pass Phrase Enter a passphrase of up to 63 case-sensitive printable characters. As you enter
the passphrase, the G-302 v3 automatically generates four different WEP keys
and displays it in the key field below. Refer to Section 2.2.1 on page 26 for more
information.
At the time of writing, you cannot use passphrase to generate 152-bit WEP keys.
Transmit Key Select a default WEP key to use for data encryption. The key displays in the field
below.
Key x (where x is a
number between 1
and 4)
Select this option if you want to manually enter the WEP keys. Enter the WEP key
in the field provided.
If you select 64 Bits in the WEP field.
Enter either 10 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for
example, 11AA22BB33) for HEX key type.
or
Enter 5 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9”
(for example, MyKey) for ASCII key type.
If you select 128 Bits in the WEP field,
Enter either 26 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for
example, 00112233445566778899AABBCC) for HEX key type
or
Enter 13 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9”
(for example, MyKey12345678) for ASCII key type.
Note: The values for the WEP keys must be set up exactly the
same on all wireless devices in the same wireless LAN.
ASCII WEP keys are case sensitive.
Back Click Back to go to the Site Survey screen to select and connect to other network.