Xerox 1150 - Manual (Page 80)

72 Chapter 6 ENWW
Status light patterns
Control panel light message
Light status Condition of the printer Action
Ready
The printer is ready to print.
No action is necessary. To print a configuration page,
press and release the Go button on the printer control
panel.
Processing
The printer is receiving or
processing data.
Wait for the job to print.
Manual feed or out of memory
The printer is in manual feed
mode or out of memory. You
can continue printing.
Make sure that you have loaded the correct media. To
continue printing, press and release the Go button.
The software controls manual feed. If you do not want to
be in manual feed mode, change the setting from your
printer properties. See
Printer properties (driver) for more
information.
The page being printed might be too complex for the
printer’s memory capacity.
● To continue printing, press and release the Go
button.
● Lower the resolution. See Understanding print quality
settings for more information.
● Add more memory. See Installing a memory DIMM
(1300 series only) for more information.
Door open, media out, no print
cartridge, or media jam
The printer is in an error state
that requires operator
intervention or help.
Check the following:
● The print cartridge door is completely closed.
● Media is loaded. See Loading media into the input
trays for instructions.
● The print cartridge is correctly installed in the printer.
See
Changing the print cartridge for instructions.
● There is a media jam. See Clearing jams for
instructions.
● The left side panel is completely closed.
Symbol for “light off”
Symbol for “light blinking”
Symbol for “light on”
Light status legend