Xerox DocuPrint Printer 3 - Manual (Page 48)

Appendix B: Set an IP Address
48 ❖ Quick Network Install Guide
Dynamic Addressing (RARP/BOOTP)
The TCP/IP address is assigned automatically by the
Server. Follow the steps below:
1 Press Menu Up or Menu Down until you see:
M e n u s
E t h e r n e t M e n u
2 Press Item Up or Item Down until you see:
E t h e r n e t M e n u
I P A d d r e s s R e s .
3 Press Value Up or Value Down until you see:
I P A d d r e s s R e s .
B O O T P / R A R P
4 Press Enter.
5 Update the RARP/BOOTP server's /etc/ethers or
/etc/bootptab and the /etc/hosts files with a host name,
TCP/IP and Network addresses. Consult your UNIX
documentation for more RARP/BOOTP server
configuration details.
6 Power Off the Printer.
7 Power the printer ON and allow time for an IP address to
be assigned by the RARP/BOOTP server (this time may
vary depending on network traffic).
8 Perform the steps contained in the section of this
document entitled Appendix A: Print The
Configuration Sheet.
9 Obtain the TCP/IP address from the Configuration Sheet.