Xerox DocuPrint Printer 3 - Manual (Page 37)

OS/2 Warp Ser ver (LAN Server) Network
Quick Network Install Guide ❖ 37
OS/2 Warp Server
(LAN Server) Network
Quick Install Steps 1 Print the Configuration Sheet. Details are in this
document in Appendix A: Print The Configuration
Sheet.
2 Check the Configuration Sheet and verify that both
TCP/IP protocol and proper connector are enabled on the
printer.
3 Create a new printer to load print drivers. Details for this
are found in the Technical Information Guide.
4 Create a network printer resource and its permissions.
5 Start LPRPORTD/LPRMON, ping printer, open EPM and
send a print job to the printer.
6 Check the print job for print quality. If print quality
problems exist, use the print quality section of your
printer System Administrator Guide to correct the
problem.
7 If your print job did not print, see the Troubleshooting
section for your operating system in the Technical
Information Guide to correct the problem.