Xerox DocuPrint Printer 3 - Manual (Page 14)

Windows NT 4.x Network
14 ❖ Quick Network Install Guide
Windows NT 4.x Network
Introduction Your printer can be installed on a Windows NT network
using one of three methods:
• TCP/IP protocol
• DLC/LLC protocol
• AppleTalk protocol
The Preliminary Steps given below must be accomplished
for all printers regardless of the protocol that is being used.
Then, the Quick Install Steps will detail the installation
based on the protocol used on your network.
The CentreWare DP program on your Printer
Management Software CD-ROM can also be used to
monitor and configure the printer.
Preliminary Steps 1 Print the Configuration Sheet. Details are in this
document in Appendix A: Print The Configuration
Sheet. Retain this page for reference.
2 Check the Configuration Sheet and verify that both the
desired protocol and connector are enabled.
3 Proceed to the Quick Install Steps for your network
protocol.