Xerox DocuPrint Printer 3 - Manual (Page 38)

OS/2 Warp V4.0 and OS/2 Warp Connect 3.0 Peer-to-Peer Network
38 ❖ Quick Network Install Guide
OS/2 Warp V4.0 and
OS/2 Warp Connect 3.0
Peer-to-Peer Network
Quick Install Steps 1 Print the Configuration Sheet. Details are in this
document in Appendix A: Print The Configuration
Sheet.
2 Check the Configuration Sheet and verify that both
TCP/IP protocol and proper connector are enabled on the
printer.
3 Create a new printer to load print drivers. Details for this
are found in the Technical Information Guide.
4 Create a printer share and its access permissions (sharing
and connecting).
5 Start LPRPORTD/LPRMON, ping printer, open EPM and
send a print job to the printer.
6 Check the print job for print quality. If print quality
problems exist, use the print quality section of your
printer System Administrator Guide to correct the
problem.
7 If your print job did not print, see the Troubleshooting
section for your operating system in the Technical
Information Guide to correct the problem.