Yamaha Magicstomp BASS EFFECTS PROCESSOR - Manual (Page 10)

10
Connections
CAUTION
• In order to prevent electric shock or damage to your equipment, turn OFF
the power on the bass amp, etc., and set the MAGICSTOMP’s volume to its
minimum level before making any connections.
• Use ONLY a Yamaha AC-10 Power Adaptor (or other adaptor specifically
recommended by Yamaha).
Using another adaptor may result in damage, overheating or fire, which
can be very dangerous.
• Make sure to use the recommended AC voltage as indicated on the power
adaptor.
• The MAGICSTOMP automatically switches “ON” when power is connected and supplied to the
device.
• Connect a bass, guitar or any line level instrument such as a synthesizer, etc., to the INPUT
jack. The MAGICSTOMP can also be connected to the effect loop of an amplifier, mixer, or
other similar device.
• Set the INPUT LEVEL switch to match the output level of the instrument or device that is
connected to the MAGICSTOMP. If the sound is distorted when the switch is set to the HIGH
position, change the setting to LOW. If you feel output is low when the switch is set to the LOW
position, change the setting to HIGH.
• When using patches with stereo output, we recommend connecting the MAGICSTOMP’s out-
put jacks to a stereo device.
• When connecting the power adaptor to the MAGICSTOMP’s AC IN jack, you can wrap the
power adaptor cord around the cord hook as shown in the illustration below (this helps keeping
the plug from being accidentally pulled out).
CAUTION
• Don’t let the cord bend sharply or kink when wrapping the cord around
the hook. An excessive bend can cut the cord or start a fire.
Power adaptor cord
Cord hook
AC IN jack
05.11.17, 9:40 AM Page 10