Yamaha mLAN8E - Manual (Page 12)

12
English
Settings on the device in which the mLAN8E is installed
Cursor 2 In (input)
■
Knob 1
[ turn] Move cursor / switch pages
Move the cursor or switch pages.
[ press] Tree View
Access the Tree View screen.
■
Knob 2
[ turn] In (select input plug)
Select the mLAN8E mLAN plug that will input the signal. If a connection has already been
made, the module name and plug name will be displayed in parentheses.
❑ Setting: AD-L, AD-R, MIDI
■
Knob 3
Display only
If unconnected, this will indicate “New.”
[ press] mLAN_INIT (mLAN initialize)
Initialize mLAN-related settings. This will be executed after you reply to a confirmation dialog
box.
All connection settings will be set to “---”. The Word Clock Mode will be “Auto.”
The Nickname settings will not be initialized.
■
Knob 4
[ turn] Select connected module
Select an mLAN device on the mLAN bus (system). When you select a valid mLAN device, the
top line will show the vendor name and the Nickname.
■
Knob 5
[ turn] Select connected mLAN plug
Select an mLAN output plug on the connected mLAN device.
The connection is executed by CONNECT (press knob 5). If after making
your selection, you change pages, move the cursor, or change the Out or
Connect# settings without executing CONNECT, the selected value will be
cleared.
If there are no plugs that can be selected, this will be displayed as “---.”
[ press] CONNECT
Connect to the mLAN output plug of the selected mLAN device.
If the node number is “New,” this function will appear if you have selected a module name or
plug name that can be connected.
[ press] CUT (disconnect)
Break the selected connection.
This function will appear if you have selected an already-connected module name or plug
name.
NOTE
NOTE
NOTE