English – Yamaha mLAN8E User Manual

Page 11

English

Settings on the device in which the mLAN8E is installed

■

Knob 3

[

turn] Connect# (select connection number of the connected mLAN device)

Select the connection number of the connected mLAN device. In the case of numbers for
which a connection has already been made, the module name and plug name will be dis-
played in parentheses. If there are fewer than 62 connections, you can select “New” and cre-
ate a new connection (mLAN input plug).

❑

Setting:

1~62, New

[

press] mLAN_INIT (mLAN initialize)

Initialize mLAN-related settings. This will be executed after you reply to a confirmation dialog
box.
All connection settings will be set to “---”. The Word Clock Mode will be “Auto.”

The Nickname settings will not be initialized.

■

Knob 4

[

turn] Module (select connected module)

Select an mLAN device on the mLAN bus (system). When you select a valid mLAN device, the
top line will show the vendor name and the Nickname.

Settings cannot be modified for the connection number of an already-estab-

lished connection.

■

Knob 5

[

turn] Plug (select connected mLAN plug)

Select the mLAN input plug of the connected mLAN device.

The connection is executed by CONNECT (press knob 5). If after making

your selection, you change pages, move the cursor, or change the Out or

Connect# settings without executing CONNECT, the selected value will be

cleared.

If there are no plugs that can be selected, this will be displayed as “---.”

[

press] CONNECT

Connect to the mLAN input plug of the selected mLAN device.
If the connection number is “New,” this function will appear if you have selected a module
name or plug name that can be connected.

[

press] CUT (disconnect)

Break the selected connection.
This function will appear if you have selected an already-connected module name / plug
name.

NOTE