Zebra Technologies SL5000r/T5000r - Manual (Page 41)

41
Zebra Xilll Series SL5000r/T5000r with ZGL Emulation
Save Settings -
Permanent* - Saves changes even after
power is turned off.
Temporary - Saves until changed again or
until power is turned off.
Cancel - Cancels all changes since entering
Config mode.
Load defaults - Loads Factory defaults.
N/A
N/A
N/A
N/A
N/A
CONFIG CONTROL Menu,
Save Config. - Saves changes to 8 cust. Configs. (same
as Zebra Permanent).
NOTE: Changes to all configs. act same as Zebra
Temporary mode unless config. saved as 1 of 8 custom
Configs.
Cancel N/A - Printer auto cancels like Zebra if Config
changes are not saved or if another Config is loaded.
Load Config. - Loads Factory default and 1-8 custom
configurations.
Power-Up Config - Selects Factory or 1 of 8 custom
Configs. as power-up configuration.
Delete Config. - Deletes any of up to 8 saved custom
configurations.
Print Config. - Prints Factory, Pwr-Up, Current, All, or
custom Configs. 1-8.
Protect Configs. - When enabled, prevents saving &
overwriting any existing saved custom Config.
Name Config. 1-8 - Permits using up to 15 characters to
name a custom Config.
Format Convert – (None*, 150-300, 150-
600, 200-600, 300-600).
Selects the bitmap scaling factor. PPI/ZGL SETUP Menu,
Resolution Mode - Full*, Half
Idle Display (opt)- (Firmware ver, mm/dd/yy
(24 hr), dd/mm/yy (24 hr), mm/dd/yy (12 hr),
dd/mm/yy (12). Sets LCD display options for
real time clock, if installed. N/A
Set Date (opt)
mm/dd/yy
dd/mm/yy N/A
Set Time (opt)
24 hour
12 hour N/A
IP Resolution (opt) -
Dynamic* - Server selects IP Address.
Permanent - User selects IP Address. N/A
IP Protocols (opt) - (All*, Gleaning only,
RARP, BOOTP, DHCP).
If Dynamic set in IP Resolution, this selection
determines method(s) that the PrintServer
will receive the IP Address from the server. N/A
Table 2: ZGL Menu (continued)