beautypg.com

Pp / ^pp - programmable pause, Pq - print quantity, Pr / ^pp - print rate – Zebra Technologies SL5000r/T5000r User Manual

Page 35: Rb - define epc data structure, Rf - read or write rfid format, Rm - enable rfid motion, Rr - specify rfid retries for read/write, Rs - rfid setup, Rt - read rfid tag

background image

35

~PP / ^PP - Programmable Pause

The ~PP command takes the printer offline as soon as the current label being
printed is completed. The exact moment at which this occurs in the label
stream may not match exactly. The ^PP command takes the printer offline
after the label definition in which the command appears is finished printing.

^PQ - Print Quantity

The ^PQ command controls printing operations such as the number of labels
to print, labels printed before the printer pauses, and replications of each
serial number.

~PR / ^PP - Print Rate

This command sets the print speed of the printer in inches per second. The
exact set of available speed settings provided by the PPI is printer dependent
and may not match those available through ZPL.

^RB - Define EPC Data Structure

This command defines the structure of EPC data, which can be read from or
written to an RFID tag.

^RF - Read or Write RFID Format

This command allows you to read or write to an RFID tag. For PTX, the
starting block number is one, since we only have one block of tag data. Zebra
provides additional blocks but they are not being used.

^RM - Enable RFID Motion

This command enables or disables RFID motion. When disabled, Zebra does
not move the label. PTX moves the label if there is data to print on the label.
When enabled, both Zebra and PTX moves the label.

^RR - Specify RFID Retries for Read/Write

This command changes the number of times that the printer attempts to read
or write to a tag. By default, Zebra attempts six retries. PTX attemps two
retries. The command value ranges from 0 to 10 for Zebra and 1 to 9 for PTX.

NOTE: However, zero is not an available option for the SL5000r/T5000r

printer.

^RS - RFID Setup

This command sets up parameters including tag type, read/write position of
the transponder, and error handling. Currently, only the read/write position of
the transponder and label retry are supported by PTX.

^RT - Read RFID Tag

This command tells the printer to read the current RFID tag data. For PTX, the
starting block number is one, since we only have one block of tag data. Zebra
provides additional blocks but they are not being used.