Zebra Technologies SL5000r/T5000r User Manual
Page 26
26
Chapter
3
^B$B - UPCSHIP
Command Format: ^B$B fp, hgt, rdt, pos
b: UPCSHIP barcode command
fp: Barcode orientation
N = No Rotation (Default)
R = Rotate 90 degrees, clockwise
I = Rotate 180 degrees, inverted
B = Rotate 90 degrees, counter-clockwise
hgt: Barcode Height
Value entered in dots at the printer dpi.
The default is 10 dots or the height set by the ^BY command.
If the height exceeds the label length, then the barcode is
cut off at the bottom of the label.
rdt: Human readable data
Y = Print human readable data (Default)
N = No human readable data
pos: Human readable data print position
Y = Print it above the barcode
N = Print it below the barcode (Default)
^B$C - EAN/UCC-128
Command Format: ^B$C fp, hgt, rdt, pos, chk
c: EAN/UCC-128 barcode command
fp: Barcode orientation
N = No Rotation (Default)
R = Rotate 90 degrees, clockwise
I = Rotate 180 degrees, inverted
B = Rotate 90 degrees, counter-clockwise
hgt: Barcode Height
Value entered in dots at the printer dpi.
The default is 10 dots or the height set by the ^BY command.
If the height exceeds the label length, then the barcode
is cut off at the bottom of the label.
rdt: Human readable data
Y = Print human readable data (Default)
N = No human readable data
pos: Human readable data print position
Y = Print it above the barcode
N = Print it below the barcode (Default)
chk: Mod-103 Check Digit (only applies to subset C)
Y = Calculate and print check digit
N = No check digit (Default)