Xantrex Technology FREEDOM HW 1000 - Manual (Page 9)

975-0468-01-01 vii
This guide for use by qualified installers only
Personal Precautions When Working With Batteries
1. Study and follow all of the battery manufacturer's specific
precautions, such as removing or not removing cell caps while
charging, and recommended rates of charge.
2. Add distilled water in each cell until battery acid reaches the level
specified by the battery manufacturer. This helps to purge excessive
gas from cells. Do not overfill. For a battery without cell caps,
carefully follow manufacturer's recharging instructions.
3. Make sure the area around the battery is well ventilated.
4. Never smoke or allow a spark or flame near the engine or batteries.
5. Use extra caution to reduce the risk or dropping a metal tool on the
battery. It could spark or short circuit the battery or other electrical
parts and could cause an explosion.
6. Remove all metal items, like rings, bracelets, and watches when
working with batteries. Batteries can produce a short circuit current
high enough to weld metal to skin, causing a severe burn.
7. Have someone within range of your voice or close enough to come to
your aid when you work near a lead-acid battery.
8. Have plenty of fresh water and soap nearby in case battery acid
contacts skin, clothing, or eyes.
9. Wear complete eye protection and clothing protection. Avoid
touching your eyes while working near batteries.
10. If battery acid contacts skin or clothing, wash immediately with soap
and water. If acid enters your eye, immediately flood it with running
cold water for at least twenty minutes and get medical attention
immediately.
11. If you need to remove a battery, always remove the ground terminal
from the battery first. Make sure all accessories are off so you don’t
cause an arc.
WARNING: B
ATTERIES PRESENT
R
ISK OF
E
LECTRICAL
S
HOCK
,
B
URN FROM
H
IGH
S
HORT
-C
IRCUIT
C
URRENT
, F
IRE OR
E
XPLOSION FROM
V
ENTED
G
ASES
. O
BSERVE
P
ROPER
P
RECAUTIONS
.