beautypg.com

Step 3: mounting the freedom hw – Xantrex Technology FREEDOM HW 1000 User Manual

Page 25

background image

Basic Installation Procedures

975-0468-01-01

1–13

This guide for use by qualified installers only

Step 3: Mounting the Freedom HW

To mount the Freedom HW:

1. Remove the Freedom HW from its shipping container, verify that all

components are present, and record relevant product information on
Freedom HF Inverter/Charger Owner’s Guide (Doc. Part Number:
975-0467-01-01) Warranty section.

2. Select an appropriate mounting location and orientation. (See Figure

1-3 below.) To meet regulatory requirements, for use in on-land
applications, the Freedom HW must be mounted in one of the
following orientations:

Under a horizontal surface (see 1)

In a horizontal position on a vertical surface (see 2)

On a horizontal surface (see 3)

3. Look for the mounting template and unfold. Tape it to the mounting

surface and pilot-drill the desired number of mounting holes. Remove
the template.

4. Fasten the Freedom HW to the mounting surface. If you are mounting

the unit on a wall or bulkhead, use #12 or #14 pan-head wood or sheet
metal screws to secure it to the framing behind the wall or bulkhead.
Alternatively, use nut inserts and 1/4-20 machine screws.

Figure 1-3 Approved Mounting Orientations

1

2

3