Yamaha RX-Z7 - Manual (Page 116)

116
En
Remote control features
1
Press G
SETUP on the remote control using
a ballpoint pen or similar object.
“SETUP” appears in the display window (4) on the
remote control.
2
Press 9k / n repeatedly to select “LIGHT”
and then press 9
ENTER.
“LIGHT” and the current “LIGHT” setting appears in
the display window (4) alternately.
3
Press 9k / n to select the desired setting
and then press 9
ENTER.
4
Press G
SETUP again to exit from the setup
mode.
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input area. For a complete list of available remote
control codes, refer to “List of remote control codes” in
“Appendix” (separate booklet).
The following table shows the default component
(Library: component category) and the remote control
code for each control area.
Remote control code default settings
You may not be able to operate your Yamaha component even if
a Yamaha remote control code is preset as listed above.
In this case, try setting another Yamaha remote control code.
1
Check the remote control code for your
component in advance.
For a complete list of available remote control codes,
see “List of remote control codes” in “Appendix”
(separate booklet).
2
Set the operation mode selector on the
remote control to F
SOURCE.
If you want to set the remote control code for “TV”,
set the operation mode selector to FTV.
Setting the backlight mode of the
remote control
Choice Descriptions
ON Lights up the backlight when a button is
pressed.
OFF Lights up the backlight only when
6LIGHT is pressed.
LIGHT
Setting remote control codes
Control
area
Library
(component
category)
Manufacturer
Default
code
MULTI DVD Yamaha 04306
V-AUX — — —
PHONO — — —
DOCK SOURCE Yamaha 00012
BD
HD DVD
BD Yamaha 04706
DVD DVD Yamaha 04306
CD CD Yamaha 01205
MD
CD-R
CD-R Yamaha 01405
CBL
SAT
— — —
TV — — —
DVR DVR Yamaha 00707
VCR — — —
TUNER SOURCE Yamaha 00012
XM SOURCE Yamaha 00012
SIRIUS SOURCE Yamaha 00012
USB
NET
SOURCE Yamaha 00012
Note