Yamaha DGC1B - Manual (Page 16)

4
Chapter 2
Names of Parts and Their
Functions
This chapter describes the functions of the buttons and other parts of the Disklavier.
Control Unit — Front Panel
1 [STANDBY / ON] button
Turns on the Disklavier or puts it in Standby
mode. Press once to turn it on, and once again to
put it in Standby mode.
Note: In Standby mode, the Control Unit is in effect
turned off. However, electrically it is in a state
in which a very small quantity of power is
being consumed, as the MAINS switch is still
on and the Disklavier is still connected to the
AC power receptacle.
2 Remote control sensor
When using the remote control, point it toward
this sensor.
3 Display (LCD)
Shows various information.
4 DRIVE indicator
Indicates the selected disk.
5 [SELECT] buttons
Used to select a disk. Toggles the floppy disk,
CD, and Memory Disks (0 ~ 9 and A ~ F).
6 CD drive
Insert a PianoSoft.PlusAudio or other audio or
audio/MIDI CD here.
7 CD eject button
Used to open the CD drive.
8 Floppy disk drive
Insert a floppy disk here.
9 Floppy disk eject button
Used to eject the disk from the floppy disk drive.
0 [PLAY/PAUSE] button
Used to start and pause playback.
q [STOP] button
Used to stop playback and recording.
PLAY/PAUSE STOP REC
PART
L R
ENTER
VOICE FUNC.
METRO-
NOME BALANCE
TRANSPOSE
TEMPO
+/YES
GENERAL
INSTRUMENT
CONTROL UNIT DKC60RCD
STANDBY
ON
DRIVE SELECT
2 3 8 9
0 q w e r t y ui o p a s
1 4 5 6 7