ZyXEL Communications Prestige 128L - Manual (Page 89)

Filter Configuration 77
Novell IPX Filter Rule
This section will show you how to configure the protocol-dependent
parameters for an IPX filter. The fields in the menu are displayed in
bold type.
Figure 9-6 Menu 21.1.3 - IPX Filter Rule
1. IPX Packet Type - Enter the IPX packet type value of the packet
you wish to filter. This value should be two hex-bytes.
2. Destination/Source Network # - Enter the four hex-byte
destination/source network numbers of the packet that you wish to
filter.
3. Destination/Source Node # - Enter in the six hex-byte value for
the destination/source node number of the packet you wish to filter.
4. Destination/Source Socket # - Enter the destination/source
socket number of the packets that you wish to filter. This should be
a 4-byte hex value.
5. Destination/Source Socket # Comp - You can select what
comparison quantifier you wish to use to compare to the value given
in Destination Socket # and Source Socket #.