ZyXEL Communications Prestige 128L - Manual (Page 28)

16 Installation
Connecting Your Computer and Your Prestige
For the initial setup of your Prestige, use the provided RS-232 cable
and communications software to configure your Prestige.
After your Prestige has been successfully installed, you can modify the
configuration through a remote Telnet connection. See Chapter 12 for
detailed instructions on using Telnet to configure your Prestige.
Connecting the RS-232 Cable to your Prestige
One 9-25 pin adapter is included with your Prestige. To connect a RS-
232 cable, connect the 9-pin end of the cable to the DTE port on the
back panel of the Prestige. Connect the other end to the RS-232 cable
connected to the serial port (COM1, COM2, or any other COM port)
of your computer.
Connecting an IDSL Line to your Prestige
Plug one end of the IDSL line included in your package into the socket
on the rear panel of your Prestige labeled Line, and the other end into
the IDSL wall jack or another Prestige.
O N
OTE
: T
HE
IDSL
JACK IS FOR
IDSL
LINE CONNECTION ONLY
. C
ONNECTION OF A
PHONE LINE MAY RESULT IN DAMAGE TO YOUR
P
RESTIGE
.
A
TTENTION
: L A FICHE IDSL EST DESTINÉE UNIQUEMENT POUR LA CONNEXION SUR UNE
LIGNE
RNIS. L
A CONNEXION SUR UNE LIGNE TÉLÉPHONIQUE PEUT
ENDOMMAGER VOTRE ADAPTATEUR DE TERMINAL
.
Connecting an Ethernet Cable to your Prestige
Your Prestige supports two types of Ethernet connections. The
connection procedure differs for each one; follow the one that is
appropriate for your installation.
UTP