ZyXEL Communications Prestige 128L - Manual (Page 77)

Bridging Configuration 65
Figure 8-8 Menu 12.4 - Bridge Static Route
1. Route Name - For identification purposes enter a name for the
bridge static route.
2. Active - Indicates whether the static route is active or not.
3. Ether Address -Enter the MAC address of the destination device
that you wish to bridge your packets to.
4. IP Address - If available, enter the IP address of the destination
device that you wish to bridge your packets to.
5. Gateway Node - Enter the number (1-4) of the Remote Node that
is linked to this static route. When an incoming packet’s destination
Ether (MAC) address matches the value entered above, then it will
trigger a call to this Remote Node.
Once you have completed filling in the menu, press ENTER at the
message: Press ENTER to Confirm ... to save your selections, or press
ESC at any time to cancel your selections.