ZyXEL Communications Prestige 128L - Manual (Page 51)

Remote Node Configuration 39
5
Remote Node Configuration
A Remote Node represents both a remote gateway and the internet
behind it, across an IDSL connection. A Remote Node is required for
connecting to the remote network directly. Note that when you use
Menu 4 to configure the Internet, your Prestige will automatically add a
Remote Node for you.
Even though you can configure up to four remote nodes, the first active
remote node will be used to connect to the remote LAN. It is a good
practice to keep only one active remote node for your Prestige.
In this chapter, we will discuss the parameters that are protocol
independent. The protocol dependent configuration will be covered in
subsequent chapters. For TCP/IP, see Chapter 6. For IPX, see
Chapter 7. For bridging, see Chapter 8.
From the Main Menu, enter 11 to go to Menu 11 - Remote Node
Setup. When in menu 11, enter the number of the Remote Nodes (1 to
4) that you wish to configure as shown below: