Yamaha AV1 - Manual (Page 35)

E-33
English
Normally, if station signals are strong and there is no
interference, quick automatic-search tuning (Automatic
tuning) is possible. However, if signals of the station
you want to select are weak, you must tune to it
manually (Manual tuning).
Automatic tuning
1
Select the built-in tuner as the input source by
pressing the TUNER input selector button.
2
Select the reception band [FM or AM (MW or LW)]
by pressing the PRESET/BAND button confirming it
on the display.
* Do not select a preset tuning mode (Do not
select the mode in which “PRESET” lights up on
the display.)
3
Press the AUTO/MAN’L button so that “AUTO”
appears on the display.
(In this mode, stations are received in stereo or
monaural automatically.)
4
Press “ ” to tune to a higher frequency, or press
“ ” to tune to a lower frequency.
5
If the station where tuning search stopped is not the
desired one, follow step 4 again.
* If the tuning search does not stop at the desired
station, change to the Manual tuning method as
described on the next page.
* ST (Stereo) indicator will light up when an FM
stereo broadcast with sufficient signal strength is
received.
“AM” is for U.S.A., Canada, Australia, Singapore
and General models.
“MW/LW” is for U.K. and Europe models.
LISTENING TO A RADIO PROGRAM
TUNING OPERATION
PONENT SYSTEM AV–1 OPEN/CLOSE CD TUNER TAPE/MD VCR
/
TRACK PRESET PRO LOGIC DSP OFF
ENHANCED MONO MOVIE
ROCK CONCERT VIDEO
DISCO HALL STADIUM
MEMORY
TIME ADJ
AUTO/MAN’L
TIMER
PRESET/BAND
HOUR MIN
REPEAT
DISPLAY
/ /
VIDEO 2
POWER
SLEEP
VOLUME
TEST
ON/OFF
C/R/D
CENTER/REAR
/DELAY
PRESET
TUNER
CD
DSP
LEVEL
PROGRAM
SUBWOOFER
INPUT
AMP
<
Except U.K. and Europe models
>
<
U.K. and Europe models
>
MHz
AUTO ST
3 2 4
1
1
or ,
or