Yamaha AV1 - Manual (Page 14)

E-12
FROM TCD–AV1 FRONT
INPUT
SYSTEM
CONNECTOR
MARK
CENTER REAR REAR
R L R C L
L
R
ANTENNA
FM
75 Ω UNBAL. GND AM
VIDEO
SIGNAL
TO SW-AV1
MARK
SYSTEM
CONNECTOR
AUDIO
OUTPUT
IN
MONITOR OUT
VIDEO 1
OUT IN
VCR
OUT IN
TAPE/MD
FROM TCD–AV1
INPUT
SYSTEM
CONNECTOR
MARK
L
R
TO SW-AV1
MARK
SYSTEM
CONNECTOR
AUDIO
OUTPUT
■ Making a system connection between the main control unit (TCD-AV1) and
the power amplifier/subwoofer (SW-AV1)
CONNECTIONS
CONNECTIONS
1
Connect the SYSTEM CONNECTOR terminals on
both units with each other by using the provided
system connector cable.
* When connecting the system connector cable to
both terminals, take notice of the directions of
each SYSTEM CONNECTOR terminal’s face.
2
Connect the AUDIO OUTPUT terminals on TCD-
AV1 to the INPUT terminals on SW-AV1 by using
the provided connection cord.
* Make sure to connect the red plug of the
connection cord to the “R” (right) terminal and
connect the white plug to the “L” terminal.
Power amplifier/subwoofer
(SW-AV1)
Main control unit (TCD-AV1)
Audio
connection
cord
(provided)
System
connector
cable
(provided)
Never plug the AC supply lead of this system into the AC outlet until all connections are
completed.
When you have finished placing or installing all units in this system, begin making connections by following
instructions on this section.
This system needs 6 kinds of connections: system connection, speaker connection, antenna connection and external
unit connection, however the order of them is not important.
1
2
Caution
Be careful not to damage
the system connector
cable by placing
something heavy on the
cable, by fixing metal
fittings on the cable, by
tugging the cable, and so
on. Damaging the cable
will lead this system to a
breakdown.