Yamaha AV1 - Manual (Page 27)

E-25
English
ADJUSTMENTS BEFORE LISTENING OPERATIONS
SETTING THE CLOCK
1
While the power is on, press the DISPLAY button to
display the time. If this system is in the standby
mode, you can proceed to the next step.
2
While holding the TIME ADJ button pressed, press
the HOUR button and set the hour.
* Press the HOUR button once to advance the time
by 1 hour. Press and hold to advance
continuously.
3
While holding the TIME ADJ button pressed, press
the MIN button and set the minute.
* Press the MIN button once to advance the time by
1 minute. Press and hold to advance
continuously.
* The hour setting will not advance even if minute is
advanced from “59” to “00”.
Europe, U.K., Australia and Singapore models use
a 24-hour display. U.S.A. and Canada models use
a 12-hour display shown by “AM (PM) 12:00”. For
General model, either the 24-hour display or the
12-hour display is selected depending on the
setting of the FREQUENCY STEP switch on the
rear panel, so you cannot select a desired type
freely.
In the event of a power failure or when the AC
supply lead is disconnected.
The time display will go out, however, the clock will
function for about 5 minutes without power supply. So
you do not have to reset the time if the AC power
supply is resumed within about 5 minutes.
When the AC power supply is resumed after more than
5 minutes pass without power supply, the time display
will flash on and off to indicate that the time must be
reset.
If desired, you can adjust brightness of the display.
1
Press and hold the DISPLAY button for more than 2
seconds so that “DIMMER±0” appears on the
display.
2
Holding the DISPLAY button pressed, press the
“
/ ” button once or more to increase or press
the “ / ” button once or more to decrease
brightness.
This adjustment can be made even though this system
is in the standby mode.
Control range
When the power is on: ±0 to –6 (Preset value: ±0)
In the standby mode: +3 to –3 (Preset value: ±0)
ADJUSTING BRIGHTNESS OF THE DISPLAY
MEMORY
TIME ADJ
AUTO/MAN’L
TIMER
PRESET/BAND
HOUR MIN
REPEAT
DISPLAY
/ /
MEMORY
TIME ADJ
AUTO/MAN’L
TIMER
PRESET/BAND
HOUR MIN
REPEAT
RDS MODE RDS START FREQ PS/PTY/RT/CT
DISPLAY
/ /
MEMORY
TIME ADJ
AUTO/MAN’L
TIMER
PRESET/BAND
HOUR MIN
REPEAT
RDS MODE RDS START FREQ PS/PTY/RT/CT
DISPLAY
/ /
1
2
3
Changes
Changes