Yamaha CRW8824IX Series - Manual (Page 19)

Setup Procedures
Connections
Before connecting the CRW8824IX drive and the computer as described
below, make sure that you have installed appropriate CD writing software
(P. 3, 4). If you newly install the CD writing software, first disconnect all
IEEE1394 devices from your computer. After properly installing the
software, you are ready to connect the devices. For information about how
to install the software, refer to the documentation that came with it.
If your computer has no built-in IEEE1394 port, you will first need to install an
IEEE1394 interface card (purchased separately). For information about how to
install the card, refer to the documentation that came with it.
1 Make sure that the computer is turned on.
2 Make sure that the drive is turned OFF (the POWER switch is not
depressed).
Power ON Power OFF
3 Connect the supplied power cable to the AC IN socket on the drive’s rear
panel.
10