beautypg.com

Levelling the appliance, Connecting to gas supply – Zanussi ZKG5020 User Manual

Page 28

background image

min 150

min 7

min 1

750

max 400

• For appliances installed in the Republic of

Ireland please refer to NSAI-Domestic Gas
Installation IS813 Current Edition Section7
Permitted Locations of appliance Table4---
Locations and Permanent Ventilation re-
quirements-flueless appliances. Note: -
L.P.G. cookers MUST NOT be installed
below ground level i.e. in a basement or
aboard any boat, yacht or other vessel.

Levelling the appliance

• Adjustment to suit floor conditions or height

is obtained by rotating clockwise or anti
clockwise the feet at the front and rear of the
appliance. A spirit level should be placed on
one of the shelves to confirm the appliance
is correctly levelled.

Connecting to gas supply

• This appliance is designed to be installed

with an appliance flexible connection only.

• Supply piping should not be less than R3/8.

Connection is made to the Rc ½ (½" B.S.P)
female threaded entry pipe located just be-
low the hob level on the rear left hand side
of the appliance.

IMPORTANT!
Only liquid sealants to be used when inlet gas
pipe is fitted i.e.: do not use P.T.F.E. sealant
tape.

• Carry out a gas tightness test after connect-

ing to the gas supply.

• The gas bayonet connector must be fitted in

the enlarged area indicated.

• Take into account that it must be possible to

pull the appliance forward sufficiently. En-
sure the hose does not become trapped
when pushing the appliance into position.

28