ZyXEL Communications P-660RU-T V2 - Manual (Page 110)

Chapter 13 Maintenance
P-660RU-T v2 User’s Guide
110
13.6 Firmware Screen
Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
.bin extension, for example, "ZyXEL.bin". The upload process uses HTTP (Hypertext
Transfer Protocol) and may take up to two minutes. After a successful upload, the system will
reboot.
1
Only use firmware for your device’s specific model. Refer to the label on the
bottom of your device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your ZyXEL Device.
Figure 55 Firmware Upgrade
The following table describes the labels in this screen.
ATM Loopback
Test
Click this button to start the ATM loopback test. Make sure you have configured at
least one PVC with proper VPIs/VCIs before you begin this test. The ZyXEL Device
sends an OAM F5 packet to the DSLAM/ATM switch and then returns it (loops it
back) to the ZyXEL Device. The ATM loopback test is useful for troubleshooting
problems with the DSLAM and ATM network.
Upstream Noise
Margin
Click this button to display the upstream noise margin.
Downstream
Noise Margin
Click this button to display the downstream noise margin.
Back Click this button to go back to the main Diagnostic screen.
Table 31 Diagnostic: DSL Line (continued)
LABEL DESCRIPTION
Table 32 Firmware Upgrade
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse ... to find it.
Browse... Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.