Yamaha CLP-230 - Manual (Page 60)

Connections
CLP-240/230 Owner’s Manual
ENGLISH
60
Connecting a Personal Computer
By connecting a computer to the Clavinova's USB [TO HOST] terminal, you can transfer data
between the instrument and the computer via MIDI. To do this, install the USB MIDI driver and
Musicsoft Downloader software from the included CD-ROM.
CAUTION
When connecting the Clavinova to a personal computer, first turn off the power to both the Clavi-
nova and the computer before connecting any cables. After making connections, turn on the
power to the computer first, then to the Clavinova.
CAUTION
If you are not using the connection between the Clavinova and your computer, you must discon-
nect the cable from the USB [TO HOST] terminal. The Clavinova may not operate correctly if a
cable is left connected.
Use a USB cable to connect the USB port on your computer to the USB [TO HOST]
terminal on the Clavinova.
TERMINOLOGY
Driver:
A driver is software that provides
a data-transfer interface between
the computer’s operating system
and a connected hardware
device. You need to install a USB
MIDI driver to connect the com-
puter and the instrument.
NOTE
• The instrument will begin trans-
mission a short time after the
USB connection is made.
• When using a USB cable to
connect the instrument to your
computer, make the connec-
tion directly without passing
through a USB hub.
• For information on setting up
your sequence software, refer
to the owner’s manual of the
relevant software.
USB cable
Instrument
Computer
USB [TO HOST] terminal
USB
TO DEVICE TO HOST