Xerox 92C - Manual (Page 41)

Printer components and options
System Overview Guide 3-5
Power on/off
switch
This switch controls power to the printer and is used primarily by
service representatives.
Sample button The sample feature is not used.
Continue button The Continue button resumes printing when it is pressed.
While it is formatting a complex page, the printer controller may
cycle down the printer if the page image is not available within a
certain amount of time. If this occurs, the following message
appears:
Press to resume printing
You can ignore this message. As soon as the page image is
available, the printer controller cycles up the printer and printing
automatically resumes.
Stop button Pressing the Stop button halts printing.
Fault code display When enabled by a service representative, shows the number of
completed prints and printer fault codes. When a fault code
displays here, the corresponding message appears in the
message display.
Information button When “i” appears on the message display, you can press this
button for additional information on printer operation. You can
press the button repeatedly for more information as long as “i”
appears.
Sample tray This output tray receives sample prints of system files, rejected
prints, and transparencies. The capacity of the sample tray is
100 sheets of 20-pound or 80 gsm bond. There is no tray full
sensor, therefore, empty this tray regularly to avoid paper jams.
Dual stacker trays
1 and 2
Each output stacker tray has a capacity of 750 sheets of 20-
pound or 80 gsm bond (1500 sheets total capacity). An alternate
to the dual stacker configuration is the stitcher/stacker.
Feeder trays The standard configuration contains two feeder trays with the
following capacities (based on 20-pound or 80 gsm bond):
• Tray 1: 1000 sheets
• Tray 2: 500 sheets. (Except for capacity, this tray is identical
to tray 1.)