ZyXEL Communications P-660R-Tx v2 Series - Manual (Page 48)

P-660R-Tx v2 Series User’s Guide
Chapter 3 Wizard Setup 49
Figure 12 Internet Access Wizard Setup: LAN Configuration
The following table describes the labels in this screen.
Table 9 Internet Access Wizard Setup: LAN Configuration
LABEL DESCRIPTION
LAN IP Address Enter the IP address of your ZyXEL Device in dotted decimal notation, for
example, 192.168.1.1 (factory default).
Note: If you changed the ZyXEL Device 's LAN IP address, you
must use the new IP address if you want to access the
web configurator again.
LAN Subnet Mask Enter a subnet mask in dotted decimal notation.
DHCP
DHCP Server From the DHCP Server drop-down list box, select On to allow your ZyXEL
Device to assign IP addresses, an IP default gateway and DNS servers to
computer systems that support the DHCP client. Select Off to disable DHCP
server.
When DHCP server is used, set the following items:
Client IP Pool Starting
Address
This field specifies the first of the contiguous addresses in the IP address
pool.
Size of Client IP Pool This field specifies the size or count of the IP address pool.
Primary DNS Server Enter the IP addresses of the DNS servers. The DNS servers are passed to
the DHCP clients along with the IP address and the subnet mask.
Secondary DNS Server As above.
Back Click Back to go back to the previous screen.
Finish Click Finish to save the settings and proceed to the next wizard screen.