ZyXEL Communications P-660R-Tx v2 Series - Manual (Page 37)

P-660R-Tx v2 Series User’s Guide
38 Chapter 2 Introducing the Web Configurator
WAN WAN Setup Use this screen to change the ZyXEL Device’s WAN remote
node settings.
WAN Backup Use this screen to configure your traffic redirect properties and
WAN backup settings.
NAT SUA Only Use this screen to configure servers behind the ZyXEL Device.
Full Feature Use this screen to configure network address translation
mapping rules.
Security Use this screen to configure Internet security and apply the
predefined filter rules.
Dynamic DNS Use this screen to set up dynamic DNS.
Time and Date Use this screen to change your ZyXEL Device’s time and date.
Remote
Management
Use this screen to configure through which interface(s) and from
which IP address(es) users can use Telnet/FTP/Web to manage
the ZyXEL Device.
UPnP Use this screen to enable UPnP on the ZyXEL Device.
Maintenance
System Status This screen contains administrative and system-related
information.
DHCP Table This screen displays DHCP (Dynamic Host Configuration
Protocol) related information and is READ-ONLY.
Any IP Table This screen shows current read-only information of all network
devices that use the Any IP feature to communicate with the
ZyXEL Device.
Diagnostic General These screens display information to help you identify problems
with the ZyXEL Device general connection.
DSL Line These screens display information to help you identify problems
with the DSL line.
Firmware Use this screen to upload firmware to your ZyXEL Device.
Configuration This screen is only available on the P-660R-T1C v2. Use these
screens to backup, restore or reset the configuration of your
ZyXEL Device.
LOGOUT Click this label to exit the web configurator.
Table 3 Web Configurator Screens Summary (continued)
LINK SUB-LINK FUNCTION