User instructions, Running the appliance – Yeoman YM-CL5MF User Manual
Page 7
7
USER INSTRUCTIONS
5.6 Burning Solid Fuel
Solid Fuel can only be burned in a multi-fuel stove.
Only for use with recommended fuels (see User
Instructions, Section 3).
Set air controls (see Diagram 9).
PR8727
Airwash: 50%
Primary Air: 50%
5.7 De-ash the fire bed before re-fuelling (see User Instructions,
Section 7).
—Open the Primary Air Control fully to establish a glowing
bed before adding new fuel.
—Burn new fuel at a high temperature for a few minutes
before adjusting the Primary Air Control to the desired
setting.
—Refuel little and often for clean, efficient burning.
5.8 Experience establishes control settings to suit personal
preferences.
5.9 Do not burn large amounts of fuel with the Primary Air
Control
on a low setting for long periods of time. This
reduces the glass cleaning effect of the Airwash and causes
tars and creosotes to build-up in the appliance and flue
system.
5.10 When in use, burning the appliance at a high temperature
for a short period also reduces tars and creosotes.
5.11 You must burn only anthracite or smokeless fuels
suitable for use in closed appliances
.
PR8742
Air Inlets
Log Guard
Mutli-fuel Stove
—Close the door.
5. RUNNING THE APPLIANCE
5.1 Burning Wood
—Close the Primary Air control and use the Airwash to
control the temperature (see Diagram 8).
PR8726
Airwash: Adjust
—Wood burns best on a bed of ash (approx. 25mm (1")
deep).
—Rake the embers evenly over the firebed and open
the Airwash Control fully for a few minutes before
re-fuelling.
5.2 Burn new logs at a high temperature for a few minutes
before adjusting the Airwash control.
Refuel little and often for clean, efficient burning.
5.3 Experience establishes settings to suit personal preferences.
5.4 Do not burn large amounts of fuel with the Airwash
Control
closed for long periods of time. This reduces the
glass cleaning effect and causes tars and creosotes to build-
up in the appliance and flue system.
5.5 When in use, burning the appliance at a high temperature
for a short period also reduces tars and creosotes.