Yeoman YM-CL5MF - Manual (Page 21)

21
INSTALLATION INSTRUCTIONS
3. FITTING AND REMOVAL OF
THE FIREBRICKS
3.1 Remove the firebricks as part of the routine maintenance.
This can be carried out without the use of tools.
3.2 Allow the appliance to cool fully before removing firebricks.
3.3 Take care when handling, as bricks can become fragile after
use. Life span depends on the type of fuels burnt and the
level of use.
— Replace damaged bricks as soon as possible.
3.4 When removing the firebricks make note of the position of
the chamfered edges and cutouts.
PR8737
Chamfered
edge
Chamfered edge
Cutouts
—Replace in the same orientation.
4. FITTING AND REMOVAL OF
THE BAFFLE
4.1 The appliance is fitted with a baffle in the top of the firebox
to maintain efficient combustion.
PR8754
Support Pin
4.2 Allow the stove to cool fully before removing the baffle
system.
4.3 To remove the baffle:
—Remove the log guard from the stove for access.
—Lift the front edge of the baffle to clear the support bars.
—Pull the baffle forward to disengage the rear edge from
the location above air inlet holes.
—Rotate the baffle to remove from the firebox through the
door opening.
PR7076
Front
—Replace in reverse order.
4.6 Remove and clean the baffle system to ensure the flue ways
are clear of soot and debris and to ensure the safe, efficient
operation of the stove. The frequency of cleaning will
depend on the stove operating conditions.
4.7 The baffle system is designed to give safe and efficient
operation of the stove. Replace any damaged baffle
immediately.
4.8 Do not modify the baffle system.
5. REMOVAL OF RIDDLING MECHANISM
To maintain good working condition the multi-fuel grate
can be removed for cleaning.
5.1 Remove ashpan, log guard, baffle and firebricks (see
preceding sections).
5.2 Remove centre grate (see Diagram 7).
PR8845
Centre grate
5.3 Remove main grate (see Diagram 8).