Yamaha CLP-130 - Manual (Page 34)

CLP-130/120 Recording Your Performance
ENGLISH
34
Changing the Initial Settings (Data recorded at the
beginning of a song)
The initial settings (data recorded at the beginning of a song) can be changed after the recording.
For example, after recording, you can change the voice to create a different ambience or adjust the
song tempo to your taste.
You can change the following initial settings.
Individual Tracks
• Voice selection
• [VARIATION] ON/OFF (CLP-130)
• [REVERB] depth
• [EFFECT] depth
• Dual mode voices
• Split mode voices (CLP-130)
Entire Song
• Tempo
• Time signature (beat)
• [REVERB] type (including OFF)
• [EFFECT] type (including OFF)
1. Engage Record mode and select a track to change the initial settings.
The indicator glows red. (Data shared by two tracks can be changed via either track.)
2. Change the settings via the panel controls.
For example, if you wish to change the recorded voice from [E. PIANO 1] to
[E. PIANO 2] , press the [E. PIANO 2] button.
Be careful not to press the SONG [START/STOP] button or a key on the keyboard,
either of which will start recording and erase all previously-recorded data on the
selected track.
3. Press the [REC] button to exit Record mode.
Be careful not to press the SONG [START/STOP] button or a key on the keyboard,
either of which will start recording and erase all previously-recorded data on the
selected track.
NOTE
You can cancel changes made
to the initial settings by select-
ing a different track after Step 2,
then exiting Record mode dur-
ing Step 3 without pressing the
[REC] button. (Changes made
to the data shared by two tracks
are also canceled.)