Windsor Saber Glide 10052530 - Manual (Page 30)

MAINTENANCE
SGJ32 86037680 01/03/07 4-7
3. SIDE SQUEEGEE ADJUSTMENT
TO REPLACE OR ROTATE SIDE SQUEEGEE
BLADES
1. Loosen the locking knob and pivot the side
squeegee out as if to expose the brush.
2. Loosen and remove the three nuts and bolts
securing squeegee blades.
3. Remove the retaining strap and squeegee blade
and rotate or replace squeegee blade.
4. Install blade and retaining strap on locating pin
and reinstall three bolts and nuts.
5. Tighten nuts. Do not over tighten nuts as this
will damage the retaining strap and deform the
squeegee blade.
6. Pivot the side squeegee back into place and
tighten the locking knob.
ADJUSTING THE SIDE SQUEEGEE
DEFLECTION
Side squeegee should deflect approximately 3/8
in. when in use. If the blade is under curled it will
skip low spots and leave puddles. It the blade is
over curled or worn it will smear water and leave
stripes and streaks.
1. Choose a smooth level surface. Lower the
scrub deck to the floor and drive forward slowly
while observing the curl and squeegee
performance.
2. To increase the curl, turn the deflection
adjustment knob counter clockwise.
3. To decrease the curl, turn the deflection
adjustment knob clockwise.