Testing the interactive pen display – Wacom DTU-2231 User Manual
Page 46
46
46
Interactive pen display
TESTING THE INTERACTIVE PEN DISPLAY
1. If the pen display power LED does not light, check the following:
•
First verify that the light on the power adapter is on. If the light is not on, check that the power cable
is properly connected to the power adapter and to an active AC outlet.
•
Check that the power adapter cable is securely connected to the pen display and that the power
switch is turned on. The power LED will glow orange or blue whenever the pen display is on.
Important: Use only an AC adapter specified for use with your pen display. Other adapters may cause
damage to your product.
2. If there is no display:
•
Make sure that your computer is turned on. The power LED will light blue when the proper video
signal is received. It will glow orange if there is no video signal or if the computer is in a power
saving mode.
•
Verify that the pen display is connected to an active DVI or VGA connector and that the DVI/VGA
switch is set to the correct video setting.
•
Check that your video card has been properly installed and is functional. If you have another
display that is compatible with your video card, you can connect that display to the card in order to
verify that the video card is operating correctly.
3. Verify that the tablet portion of your pen display and pen are working:
•
Press the pen tip against the display and verify that the status LED lights blue.
•
If the LED does not light, verify that the USB cable is plugged into an active USB port. If the
interactive pen display is plugged into a USB hub, try plugging it directly into the USB port on your
computer.
•
Be sure that the USB port to which you are connecting has not been disabled. It may be necessary
to check your system BIOS setting to verify that you have connected the pen display to an active
USB port.
•
The status LED will light blue when the pen display is registered as a USB device and the pen tip is
pressed against the display.
4. Check the pen. If you cannot make a selection on the display screen with the pen:
•
Test the pen by pressing the pen tip or eraser against the surface of the pen display. The pen
display status LED should light blue.
•
Now, without applying pressure to the pen tip but keeping the pen within 5 mm (0.2 inch) of the pen
display surface, press the side switch. The status LED should again light blue.
•
If the status LED does not light blue for these tests, be sure you are using a pen specified for use
with your product.
•
for detailed information.
If you are still having problems, you may have a defective pen or pen display.