Wasp Bar Code WPS100 - Manual (Page 260)

9-42
Wasp WPS100 Product Reference Guide
Setup Field(s)
Table 9-1. Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the Move Cursor To Character bar code
on page 9-43, then any printable ASCII character
from the
Alphanumeric Keyboard . When this is
used, the cursor moves to the position after the
matching character. If the character is not there,
the rule fails and ADF tries the next rule.
9-43
Move Cursor to Start of Data Scan this bar code to move cursor to the
beginning of the data.
9-43
Move Cursor Past a Character This parameter moves the cursor past all
sequential occurrences of a selected character.
For example, if the selected character is ‘A’, then
the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan
the Move Cursor Past Character bar code on
page 9-44, then select a character from the
Alphanumeric Keyboard . If the character is not
there, the cursor does not move (i.e., has no
effect).
9-43
Skip Ahead “N” Characters Scan one of these bar codes to select the number
of positions ahead you wish to move the cursor. 9-44
Skip Back “N” Characters Scan one of these bar codes to select the number
of positions back you wish to move the cursor.
9-48
Send Preset Value Send Values 1 through 6 by scanning the
appropriate bar code. These values must be set
using the prefix/suffix values in
Table 6-4 on page
6-30 .
Value 1 = Scan Suffix; Value 2 = Scan Prefix
Value 6 = FN1 Substitution Value
9-51