Scanning in single-line mode, Scanning in single-line mode -2 – Wasp Bar Code WPS100 User Manual
Page 22
2-2
Wasp WPS100 Product Reference Guide
Scanning in Single-Line Mode
Install and program your scanner. (Refer to each host chapter and
Chapter 8, Miscellaneous Scanner Options
, and
Chapter 9, Advanced Data Formatting
for instructions on programming your scanner.) If
you need assistance, contact Wasp Technical Support at http://support.waspbarcode.com.
1. Ensure all connections are secure. (Refer to the host chapter for your scanner.)
2. Pick up the scanner. Press and then release the trigger. A single scan line
displays.
Figure 2-2. Scanning in Hand-Held Mode
3. Ensure the scan line crosses every bar and space of the symbol.
4. Depress and hold the trigger until either:
a. The scanner reads the bar code. The scanner beeps, the LED flashes and the
laser turns off.
b. The scanner does not read the barcode and the laser turns off.
5. Release the trigger. This causes the aim scan line to reappear. To read another
bar code in single-line mode, repeat steps 2, 3 and 4. This step can be repeated
as often as desired.
6. After a programmable time period, the omni-directional scan pattern displays. This
indicates the scanner is ready to read bar codes without use of the trigger.
7. For more information on beeper definitions, refer to
.
RIGHT
012345
WRONG
012345