Wayne-Dalton Z-WAVE WDTC-20 - Manual (Page 23)

programming Target temperatures
23
Target temperatures are programmed
into the thermostat as the desired
temperature for the mode being
programmed. a total of four modes
are available for programming:
a) normal Heat, b) Save Heat,
c) normal Cool, d) Save Cool
norMaL modes are used when the
home is occupied, and SaVE EnErGY
modes are used for when the home
is unoccupied.
The SaVE EnErGY
mode is a pre-determined set-back
temperature.
1. For FIrST TIME SET-Up onLY:
Press and release the RESET button (use
a paper clip or pencil point) to initialize
the jumper settings and reset the target
temperatures to default settings
.
After reset the thermostat will be in the
OFF state
.
noTE: If this is not the first time
set-up, place your thermostat into
the OFF position. If the display is
showing the word COOL, press the
COOL button to turn the unit off.
If the display is showing the word
HEAT, press the HEAT button to turn
the unit off.
programming norMaL HEaT target
temperature:
2. Press and release the HEAT button.
HEAT will appear in the display.
3. Press and release the NORMAL
button. TARGET TEMP will appear in
the display.
4. The default NORMAL HEAT target
temperature is 70º F. To accept the
default temperature wait 5 seconds
and the unit will exit target temperature
programming mode. If the default
setting is not desired, press either the
temperature up button (+ symbol) or
temperature down button (- symbol)
until the desired target temperature
is reached. Wait 5 seconds and
the unit will exit target temperature
programming mode and save your
settings and display the ROOM TEMP.
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET
HEAT
programming
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET
COOL


3

2
1
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET

4
Continued Next Page